Replacing a water softener in Mukwonago
If your current softener was set from a guess, that is understandable in Mukwonago: the village's annual reports don't print a hardness figure. The DNR's 2026 samples put village water at about 22 to 23 grains, and a replacement starts from what your own faucet reads.
Call (262) 829-5961Mon to Fri, 7am to 5pmSet from a guess, or from a number?
With no published village figure, it is hard to know what number an older softener was set to. The DNR samples, 390 and 370 milligrams per liter at the two entry points, give a fair picture of village water.
The reading at your faucet on install day gives the number for your house, and the new softener is set from it.
Out with the old unit, in with the new
The plumber starts by unhooking the old softener. The replacement tank and salt tank take the old one's place by the supply pipe, with a bypass valve fitted and the drain hose given its air gap.
Before packing up, the plumber puts in the drinking-water faucet by the kitchen sink and tests a faucet until hardness comes back zero.
Your old unit, described over the phone
Where it is, and where the supply pipe comes in. Add your address, or that a well serves the house, and how big the household is. Nobody needs to see the old unit before you get a price.
Signs hard water is getting through
Spots and a film on drinking glasses and around faucets, plus scale in the water heater, are hard water's signature. Seeing them while a softener is running means hardness is slipping past it.
One call, one figure
A replacement is priced the same way as a first installation: one phone call and a single figure for the whole job, with no visit to sell you anything. Quote phones are staffed weekdays from 7am to 5pm.
Common questions
Do I need the brand or model of my old softener?
No. Where it sits and where the supply pipe comes in matter more, along with your address and your household's head count.
We're on our own well in the Town of Mukwonago. Is the swap any different?
The swap is the same. Only the starting number comes from somewhere else: your lab results and the reading at your faucet, in place of a DNR sample.
Should the new softener be set to the DNR's 22 or 23 grains?
Those are village entry-point readings, and they sit close together, though the setting itself follows the test at your own faucet on install day. A private well gets its own reading the same way.